A toilet that is overflowing, leaking onto the floor or refusing to flush is an emergency in a house with one bathroom. Close the shutoff valve behind the toilet by turning it clockwise, lift the tank lid and lift the flapper if water is still rising, and call. Our line is open 24/7, and a licensed plumber can be dispatched at any hour.
Do not keep flushing or plunging a toilet that is rising. Every flush sends more water into a bowl that cannot take it, and a clog that is past the toilet is a drain problem and not a toilet problem.
Emergency toilet problems and the ones we fix most
Symptom, likely cause and the usual fix
| Symptom | Likely cause | Usual fix. |
|---|---|---|
| Water runs after flushing | Worn flapper, fill valve or chain | Replace the flapper or fill valve. |
| Weak flush | Clogged rim jets, low tank water, partial clog | Clean jets, adjust the water level, clear the trap. |
| Leak at the base | Failed wax ring or loose closet bolts | Reset the toilet with a new wax ring. |
| Wobbly toilet | Loose bolts or damaged flange | Tighten, shim or repair the flange. |
| Water on the floor from the tank | Cracked tank or failed tank-to-bowl gasket | Replace the gasket or the toilet. |
| Phantom flushing | Slow leak from tank to bowl | Replace the flapper or fill valve. |
A running toilet and a high water bill
A toilet that runs or refills on its own can waste a large amount of water over a month without making a loud sound. Put a few drops of food coloring in the tank and wait a few minutes without flushing. If color shows up in the bowl, the flapper is leaking.
That is a small repair when caught early. A toilet that hisses or fills for a long time after a flush may have a fill valve problem, and that is a quick one too. If your bill is high and the toilet is the suspect, our leak detection page explains how to check the rest of the house.
Clogged toilets: when a plunger is enough and when it is not
A flat-flange plunger and steady pressure clear most single toilet clogs. If the water in the bowl rises and the plunger does not clear it in a few tries, stop and call. Overuse of a plunger can splash contaminated water and make the clog worse.
If the toilet clogs again soon, or other fixtures gurgle when it flushes, the problem is further down the line. A closet auger reaches clogs a plunger cannot, and a camera shows when the issue is a main line one, see drain cleaning.
Replacing a toilet
A toilet nearing 20 years or with a cracked bowl or tank is a good candidate for replacement. Newer models flush with less water and tend to clog less. A replacement includes removing the old toilet, checking the flange and floor, setting a new wax ring, and testing the flush.
Height, bowl shape, rough-in distance and flush rating are the choices. The rough-in, the distance from the wall to the center of the drain, is usually 12 inches, but it varies, so a quick measurement saves a return trip.
What affects the price of toilet repair or installation
You get a clear price before work starts. The factors are these.
A leak at the base of a toilet that has been going for some time can rot the subfloor. Soft flooring around the toilet is a reason to call soon.
Code points for toilets
Georgia's state minimum plumbing code is the International Plumbing Code (IPC) with Georgia amendments, enforced locally. It sets clearances and connection rules for water closets, which matter most when a toilet is replaced or reset.
Toilet overflowing or leaking? Call and a licensed plumber is dispatched.
Frequently asked questions
Yes. The line is open 24/7. Close the shutoff valve behind the toilet and keep people away from the wet floor.
A worn flapper, a misadjusted chain or a failing fill valve is the usual cause. These are quick repairs.
A failed wax ring or loose bolts are the common causes. The toilet has to be lifted and reset with a new seal.
Cracks in the bowl or tank, a very old model that clogs a lot, or repeated repairs point to replacement.
It is not recommended. It rarely clears a real clog and can damage the fixture and harm whoever works on it later.
It can be. A leaking flapper can waste a lot of water silently, and a dye test shows it in minutes.
